Front Panel LEDs

The front panel LEDs are shown in the following figure and described in the subsequent table.

Front Panel LEDs

Front-Panel LEDs

Item #	Description	Status
1	UID LED/button*	■ Solid blue = activated. ■ Flashing blue = Remote management or firmware upgrade in progress. ✔ 1 Hz = Remote management or firmware upgrade in ✔ progress ✔ 4 Hz = iLO manual reboot sequence initiated ✔ 8 Hz = iLO manual reboot sequence in progress ■ Off = deactivated.
2	Power On/Standby button/LED and system power LED*	■ Solid green = System on ■ Flashing green = Performing power on sequence ■ Solid amber = System in standby ■ Off = No power present**
3	Health LED*	■ Solid green = Normal ■ Flashing green = iLO is rebooting ■ Flashing amber = System degraded ■ Flashing red = System critical†
4	NIC status LED*	■ Solid green = Link to network ■ Flashing green = Network active ■ Off = No network activity

*When all four LEDs described in this table flash simultaneously, a power fault has occurred.

**Facility power is not present, power cord is not attached, no power supplies are installed, power supply failure has occurred, or the power button cable is disconnected.

†If the health LED indicates a degraded or critical state, review the system IML or use iLO to review the system health status.